Push rod sitting too low!

MGB discussion board for Roadster and GT classic car models.
Post Reply
Leonard MGB79
Posts: 2
Joined: Wed Jan 29, 2020 9:13 pm

Push rod sitting too low!

Post by Leonard MGB79 » Sat Feb 15, 2020 4:52 pm

Hi, number 4 pushrod sitting too low on my mgb 79.
Replaced pushrod, however still remains too low!
Any experience/ any tips please?!

Posts: 2
Joined: Fri Mar 27, 2020 10:10 am

Re: Push rod sitting too low!

Post by 1project » Fri Mar 27, 2020 10:28 am

Morning just signed up to be a member and have seen nobody has commented on your fault, there are only three options for this. 1 pushed. 2 followers badly worn and three cam lobe worn away. Would be worth removing engine side covers and pulling out followers
Check the bottom of followers where it runs on camshaft and lobe for damage.

Hope this helps

Post Reply

Return to “MGB Roadster & MGB GT Forum”

Who is online

Users browsing this forum: No registered users and 1 guest