Page 1 of 1

Push rod sitting too low!

Posted: Sat Feb 15, 2020 4:52 pm
by Leonard MGB79
Hi, number 4 pushrod sitting too low on my mgb 79.
Replaced pushrod, however still remains too low!
Any experience/ any tips please?!

Re: Push rod sitting too low!

Posted: Fri Mar 27, 2020 10:28 am
by 1project
Morning just signed up to be a member and have seen nobody has commented on your fault, there are only three options for this. 1 pushed. 2 followers badly worn and three cam lobe worn away. Would be worth removing engine side covers and pulling out followers
Check the bottom of followers where it runs on camshaft and lobe for damage.

Hope this helps
Richard